SCGM FY2017 Q4 results was announced on 22nd June. Could we improve
SCGM sales growth estimate of FY2018 by examining its capital
commitments revealed in it?
In my previous post (SCGM: “Sure Can” Growth Model), I proposed using EPM (Equipment, Plant and Machinery) investments to estimate future sales of SCGM Bhd (SCGM:KLS, stock
code: 7247). But how do we know EPM investments in future? My method
was to align it to the management discussion in FY2016. My estimates
were seen as adding EPM in the table below (re-posted):
Sales were then calculated based on the following relationship:
EPM assets (net) * EPM assets turnover = Sales
where EPM assets (net, in RM) were measured at the beginning of
financial year and EPM assets turnover was a multiple; both were
independent inputs that determined sales as an output. In FY2017, sales
were estimated to be RM 184.4m which is 3.1% higher than the un-audited
RM 178.8m from SCGM FY2017 Q4 results announcement.
Although 3.1% is a small difference, I could not yet judge whether my
estimate is good or not; because EPM assets are missing in these
quarterly results.
Improvement in quarterly results reporting
However, only recently I found an interesting thing – EPM appears under
the notes A13 Capital Commitments in quarterly results since FY2017. I
am happy to note that this is an improvement in quarterly[1] results
reporting; prior to FY2017 only aggregate PPM (Property, Plant and
Equipment) were reported. I screen-capture, combine and re-position
these figures from FY2017 Q1 to Q4 results for easy comparison.
Additionally, a chart is created for better data visualization.
Capital investment cycle
Before we attempt to get some insights from this chart, let’s briefly describe a capital investment cycle:
- Capital authorized by the board [1 day]
- Capital contracted for EPM [3 months]
- 1st installment of payment to supplier [1 day]
- EPM built and/or shipped to site [6 months]
- 2nd installment of payment to supplier [1 day]
- EPM installation and commissioning [1 month]
- Final installment of payment to supplier [1 day]
- EPM service life [5 to 10 years]
Manufacturing companies repeat this capital investment cycle in order
to maintain, expand or contract its productive assets according to their
plans. Though the sequence of the cycle is clear, the throughput time
of some steps is uncertain. The time estimates in square brackets are
from my gut feeling and are open for more accurate suggestions. It
should be noted that in step 1 and 2, the capital is NOT yet registered
in the financial statements. Rather, it appear in capital commitments in
the notes. In step 3, part of the capital is registered as capital
expenditure in the statement of cash flows and the remaining balance
takes another six to seven months. After step 7, the book value of the
EPM is fully recorded as assets in the balance sheet and will be
depreciated over the next five to ten years. It would probably take
another month or two to fully ramp up the productivity of the EPM.
Coming back to the question, could we improve SCGM sales growth
estimate of FY2018 by examining its current capital commitments in its quarterly results?
My answer is yes, this could improve the sales growth estimates of the
coming financial year, provided that step 2 takes longer than three
months which quarterly reports can capture this off-balance sheet
capital commitments. As the quarterly capital commitments is a snap-shot
of the balance at a particular date, it does NOT reveal the capital
inflow and outflow during a quarter. By comparing two consecutive
quarters, we can only know the net capital
inflow or outflow. In other words, if net change of the balance is
zero, it does not necessarily mean that there is no capital inflow and
outflow.
Hau’s view
For the specific case in SCGM 2017 quarterly results, there was RM
16.7m capital expenditure on EPM in the pipeline in Q2. As indicated in
the chart, at least RM 14.1m was already registered in the financial statements by the end of Q4. Therefore, I believe at least RM
16.7m EPM will become new production capacity in the first half of
FY2018. By chance, this RM 16.7m is in-line with my estimate of RM 16.5m
(see adding EPM in FY2018 in the table) in my last post (SCGM: “Sure Can” Growth Model). In summary, this help us improve the quality of sales estimate in FY2018 and eventually SCGM valuation.
[1] Surely
in annual report, the breakdowns of PPM (Property, Plant and Equipment)
are also reported – namely 1) land, 2) buildings, and 3) equipment,
plant and machinery. But for quarterly results, the first time was in
FY2017.
Disclaimer
All articles in this blog are intended
for research and educational purposes only. Materials in these articles
including, but not limited to, graphs, tables and screen shots
featuring investment data are not recommendations to buy or sell. The
investment analysis, information, and related comments may be
out-of-date when you read them. You should do your own due diligence
into any investment before making the decision to buy or sell. While we
aim to provide accurate data to assist you in performing your stock
valuation, we do not take responsibility of any inaccurate or omitted
data. Please verify them. We are not liable for your investment losses.
http://klse.i3investor.com/blogs/hautoinvest/126169.jsp
http://klse.i3investor.com/blogs/hautoinvest/126169.jsp